There are three different programmable speeds in MultiGov/eMultiGov.  The best way to be able to use all three speeds during flight is linking the "RPM Select" input to your radio's three position flight mode switch.  In all radio setups, the goal is to have the receiver output three stick positions (low, middle, and high) which MultiGov/eMultiGov treats as SPEED1, SPEED2, and SPEED3.  The following are ways to do this using different radios.

NOTE: Using three speeds with the "RPM Select" input is optional.  If you only need one speed (i.e. only 3D), just install the RPM Select jumper as the instructions show and set SPEED1 to your liking.  This is best for users who don't have an extra channel on their receiver or don't need another speed.

Spektrum DX7

1. Plug the "RPM Select" input to either the "GEAR" channel or "AUX2" channel of your receiver.
2. On your DX7 radio, go to the model options and assign GEAR or AUX2 (depending on which channel you plugged RPM Select into) to "F. MOD". The model options is accessed when you power on the DX7 while holding the scroll down+select buttons. See the DX7 manual if you need help for "F. MOD" assigning.
3. The MultiGov SPEED#'s should now change on the LCD as you flip your radio's flight mode switch.  If the SPEED#s are reversed, just reverse the channel that "RPM Select" is plugged into with your radio.

1. Plug the "RPM Select" input to channel 7 of your receiver.
2. Go to the "PARAMETERS" menu on your 7CHP and assign channel 7 to switch "E".
3. The MultiGov SPEED#'s should now change on the LCD as you flip your radio's flight mode switch.  If the SPEED#s are reversed, just reverse the channel that "RPM Select" is plugged into with your radio.

1. Plug the "RPM Select" input to channel 7 of your receiver.
2. Go to the "GOVERNOR" menu of your 9CHP and assign "SW" to "E". The "RATE"s on the "GOVERNOR" menu should be 0%, 50%, and 100%.
3. Go to the second page of the "GOVERNOR" menu and activate the MIX.
4. The MultiGov SPEED#'s should now change on the LCD as you flip your radio's flight mode switch.  If the SPEED#s are reversed, just reverse the channel that "RPM Select" is plugged into with your radio.

1. Plug the "RPM Select" input to the GEAR of your receiver.
2. Enable the governor menu on your 9303 and set the three values to 100, 0, -100.  Refer to your 9303 manual on how to activate the governor menu on the radio.
3. The MultiGov SPEED#'s should now change on the LCD as you flip your radio's flight mode switch.  If the SPEED#s are reversed, just reverse the channel that "RPM Select" is plugged into with your radio.

1. Plug the "RPM Select" input to the GEAR of your receiver.
2. Go to function 17 and "INH" the "GEAR SW".
3. Set programmable mix 6 to be "GEAR->GEAR" and go to the third page to tie "#FMOD->GEAR".
4. Go back to programmable mix 6 and store the two endpoints in the first page graph to -100 at 33% and 100% at 67%.
5. The MultiGov SPEED#'s should now change on the LCD as you flip your radio's flight mode switch.  If the SPEED#s are reversed, just reverse the channel that "RPM Select" is plugged into with your radio.